GUIDE TO INSTALLATION AND OPERATION
4
| DV
formats. This signal must comply with the SMPTE 12M standard.
Connect destination equipment to the LTC output BNC connector
(lower one).
5 Monitoring Output
Connect analog destination equipment to the connectors at the rear of
the DV-. Use the BNC labeled Composite or the mini-Din
labeled S-Video for video output; use the two RCA labeled R and L for
audio output.
6 AC In
Connect the supplied AC power cord into AC inlet. Both 120 VAC and
220 VAC standards are supported by the DV- built-in power
supply.
2.2 Application Examples
The following figures show typical set-ups for using the DV-.
Editing video and audio where the editing workstation operates in either
DV or 4:2:2 while the video source/destination is in the other is
illustrated in figures 2.2 and 2.3. Transferring video and audio from one
format to the other is illustrated in figures 2.4 and 2.5. Dubbing from a
DV source to a consumer VTR is shown in figure 2.6, while figure 2.7
shows how to monitor a DV-to-DV dubbing session.
Figure 2.2
Editing with a DV Workstation and a 4:2:2 VTR
DV/CONTROL
Analog Monitor
Studio VTR or Other
4:2:2 + AES Destination
4:2:2+AES+LTC
NTSC/PAL
& Audio
Monitoring
Destination
RS-422 SERIAL PORT
DV Editing System
Source
