KP-iOS
3
seleCTINg aN INsTallaTION lOCaTION
The KP-iOS is designed for use in normal interior environments. When selecting an installation location
please consider the following:
* Do not use the KP-iOS outside or in a humid or wet environment. It is not waterproof or water-resistant.
* The KP-iOS cut-out must have enough depth within the wall cavity for the KP-iOS and its connections.
* The KP-iOS has screw mounting holes on both sides that allow it to be installed up against a stud.
* Check for a strong Wi-Fi signal at the mounting location using the iPod touch that is to be installed in
the KP-iOS.
CONTROl MOUNT ReaR CONNeCTIONs
Mirage Amplifier: RJ-45 jack connects to a Mirage Amplifier via Cat5 cable. The Cat5 cable receives DC power
from the Mirage Amplifier.
WIRINg CaT5/RJ-45 Cable
The Cat5 cable and RJ-45 connector used in iPort installations must be wired according to the
T568A (Straight-Through) Standard with cables wired identically at both ends.
To prepare the Cat5 cable and RJ-45 connector for KP-iOS installation:
1. Pull the Cat5 wire through the wall between the desired locations.
2. Use a stripper or knife to strip about 1” of the cable jacket off each end of the wire.
- Be careful not to nick any of the individual wires.
3. Untwist the wire pairs and spread them flat. Arrange them as shown in Figure 2.
4. Trim the ends of the individual wires to ½” in length, making sure that they are even with each other. Flatten
the wires against each other, leaving no space between them.
5. Hold the RJ-45 connector clip-side down and
insert the Cat5 wire ends firmly into the connec-
tor. Make sure that all the wires are flat all the
way to the very front of the connector.
6. Re-confirm that the color orientation matches
the diagram and that cable jacket fits against the
connector stop.
7. Firmly crimp the RJ-45 connector with the crimp
tool. Confirm that the connector is crimped firmly
and that all the wires are flat right up against the
front of the connector. If even one of these wires
are incorrect, cut the connector off the cable and
repeat steps 2 – 7 with a new RJ-45 connector.
Figure 2: RJ-45 Connector
Содержание KP-iOS
Страница 1: ...In Wall Control Mount for iPod Touch...
