MIRAGE KP-2 Pre-Amplifier
5
−−−−
NOTE:
If the KP2RC is turned OFF, there is no placement of DC
voltage on the RF signal line, and the pre-amp remains
inactive.
In cases of very weak signal reception, you may want to change the pre-
amp gain level to the HIGH position. To do so, following these steps:
1.
Remove the four screws in the cover.
2.
Carefully pry open the silicone-sealed cover.
3.
Move the two white toggles on the black switch (located
approximately 1" from the RADIO connector) to the downward
position.
4.
Reseal the cover with a small bead of silicone or other appropriate
sealing material.
The MIRAGE KP-2 Pre-Amplifier is now ready to go! Apply power to the
KP-2 by placing the POWER switch on the KP2RC Control Unit in the ON
position. Power to the pre-amp is indicated by the LED located to the right
of the switch.
Technical Assistance
If you have any problem with this unit, first check the appropriate section
of this manual. If the manual does not reference your problem or your
problem is not solved by reading the manual you may call MIRAGE at
601-323-8287. You will be best helped if you have your unit, manual and
all information on your station handy so you can answer any questions
the technicians may ask.
You can also send questions by FAX to 601-323-6551. Send a complete
description of your problem, an explanation of exactly how you are using
your unit, and a complete description of your station.
