Mirage Reinigungstechnik H360 LB, Руководство по эксплуатации, Страница: 17 / 27

17
CBHD1 BATTERY CHARGER
The machine is furnished of incorporated electronic battery charger model CBHD1 having the technical characteristic
followings
:
1. Advanced technology High Frequency System.
2. Charging process fiilfy controlled by microprocessor.
3. UniversalInput voltage front lOOVto 240V.
4. Charging process Start in the "soft- start" mode
5. Automatic Reset upon connection ofa new battery and automatic Start of a new charging cycle.
6. Protection against polarity inversions, short-cireuits, over-voltages or anomalies
by means ofan Output relay.
7. Battery to battery charger connection without sparks on the Output terminals
with obvious advantages for the active safety, tank to the recognition of the
battery voltage downstream the normally open Output relay.
8. Signaling of possible anomalies by RED LED flashing or by YELLOW LED flashing.
9. Insensitive charge parameters in case of±10% network oscillations.
10. Efficiency >85%.
11. Output ripple at maximum charge lower than 100mV.
12. Start of the charge cycle even with 2V batteries.
CBHD1 OPERATING PRINCIPLE
On switching on a new battery charger of the CBHD1 series, the charger will check the battery voltage and
decide whether to start the charging process. If the battery is not connected to the battery charger, the
RED
led
will flash. If the result of the test is positive ofter 1 second the charging of the battery can start, with the
RED
led
on. The Output relay closes and the current of the first phase rises slowly till the nominal value programmed is
reached. If the user disconnects the battery from the battery charger during the charging process, afrer afews
seconds the battery charger reinitialize and prepare to start a new charging process. The progress of the
charging process is shown by three
LED 's : RED, YELLOW and GREEN,
as in the whole ränge of the battery
chargers.. The
GREEN
led shows the end of the charging or the last phase in case of deep charging process; in
the former case, the relay is opened to disconnect galvanic ally the battery from the battery charger.
LICHTSIGNAL
ROTE LED AUFLADEN: ERSTE STUFE
GELBE LED AUFLADEN: ZWEITE STUFE
GRÜNE LED AUFLADEN: ENDE - ODER PUFFERPHASE
ANOMALIE
BLINKENDE GELBE
LED
BATTERIE FEHLER - KEINE/DEFEKTE VERBINDUNG
BLINKENDE ROTE LED
SICHERHEITSTIMER ÜBERSCHRITTEN -
KURZSCHLUSS
ERSTER TEST
2X GRÜNE LED
JUSTIER ZUM ZTJM AUFLADEN VON GEL ODER AGM
BATTERIEN
2X ROTE LED JUSTIERUNG ZUM AUFLADEN VON PB-SÄURE
BATTERIEN
SIGNAL & MEANING
Red led ON First phase of Charge m progress
Yellow led ON Second phase of Charge in progress
Green led ON End of Charge or malnienance phase
ANOMALIES
Yellow led flashlng Unsuitable battery or un connected battery
Red led flashing Safety Timer exceedeed, internal Short circuit
IMTIALIZING TEST
Green led flashing 2 times Configured for the recharging mg of Gel or AGM batteries