1 |
P a g e
Quick Start Guide
I004493 Genio Smart Round Ambient Lamp
1. Connection Preparation
Your phone must be connected to 2.4Ghz Wi-Fi
and not to the 5GHz, To verify your mobile phone
is connected to the 2.4Ghz Wi-Fi network,
Navigate to the
Setting
menu and click on
Wi-Fi.
In this menu you will see all detectable networks
in your area. Locate the SSID for your network,
select the Wi-Fi SSID that does
NOT
end with
5GHz. (refer to the image).
Check that you have a strong Wi-Fi signal (at least
two bars) in the location where the smart device
is to be installed
If you don’t have at least two bars signal on your
phone, then you may need to reconsider the
location or getting a Wi-Fi extender to boost the Wi-Fi signal strength. Before starting
the installation, you will need to note the name of your wifi network and it’s password.
This lamp can be used manually or via the Mirabella Genio App.
For manual use, connect the cable to the
light, The light will start to blink, wait for 3
minutes until the light stops blinking, When
the light is steady on, press the button to
switch between different modes. To power
the lamp off, To power the lamp off, press
the button twice.
