Mira Leap Walk In, Руководство по установке, Страница: 3 / 17

3
1245548-W2-A
Thank you for purchasing a quality Mira product. To enjoy the full potential of your new
product, please take time to read this guide thoroughly, having done so, keep it handy for
future reference.
The following pages aim to provide comprehensive installation instructions, plus advice on
how to care and maintain your product.
We recommend that the unit is installed by a qualified plumber or engineer.
Safety Information
1. Care should be taken when drilling into walls and floors to avoid any hidden pipes or
wires.
2. We strongly recommend that all glass panels are moved by a minimum of two people
and that any protective packaging along the glass edges is kept in place for as long as
possible to prevent damage before installation.
3. During installation we recommend additional help in lifting heavy doors and side panels.
4. Wear protective footwear when lifting panels.
5. Wear safety glasses when drilling.
GENERAL INFORMATION
INTRODUCTION
Before Fitting the Enclosure
1. Ensure the tray is level and walls are vertical and square.
2. Shower fittings should be positioned such that water discharges down the centre line
of a bath or across the opening of a shower cubicle door.
3. Ensure water is not directed at the shower door or side panels. This could result in water
spraying outside of the enclosure.
4. Ensure the door opening is positioned correctly and is adequate for all users.
5. Ensure there is a complete silicone seal between the tray and finished wall.
6. Ensure the door is undamaged and no parts are missing.
General
1. Read all of these instructions and retain this guide for later use.
2. Pass on this guide in the event of change of ownership of the installation site.
3. Follow all warnings, cautions and instructions contained in this guide.
4. Remove all protective tape from the enclosure before installation.
5. Excessive flow rates may lead to overflowing and leaking.
6. Water Spray may extend beyond the entrance of walk-in enclosures and we recommend
tiling of the adjacent area.
7. We recommend a drainage test is carried out to ensure the waste is adequate for the
flow delivered.
8. Doors that open outwards may drip water onto floor, ensure the floor covering will not
be affected by water.
9. Walk ins and divider panels are designed to minimise water escaping outside the
enclosure but by their very nature are not fully water tight.