5
ACCESSORIES
Flow Regulator (12 L/min - Red) - 1641.059
If your shower has no flow control, you may
find operation of the shower on high pressure
systems too forceful. Fitting a flow regulator in
the showerhead will reduce this.
Checkvalve (360m and 360r) - 1688.282
Checkvalve (360i) - 1688.283
Cloud Spray Plate Assembly
This product is supplied configured for the
majority of showering systems including electric
showers.
Note!
for showers with a pressure of below 0.15
bar (1.5 metre head) it might be necessary to
change the Cloud sprayplate assembly for the
LC (Low Capacity) version in order to achieve a
suitable spray pattern.
Caution!
The LC sprayplate
must
not be used
on electric showers
1. Use a suitable tool to remove the grommets.
2. Using the 2.5 mm hexagonal wrench (supplied),
remove the screws.
3. Separate the sprayplate assembly into its
individual components.
4. Replace the Cloud assembly sprayplate with
the LC version.
5. Reassemble the components in reverse
order.
Grommet
Screws
Low Capacity
Sprayplate
Replacing the Cloud Sprayplate Assembly
To comply with UK Water Regulations you must
make provision to prevent the backflow of waste
water through the shower.
A hose retaining ring will allow compliance but
may restrict full use of the hose.
However, if your mixer shower is already fitted
with single inlet checkvalves then fitting the extra
showerhead checkvalve will allow compliance
without the need for the hose retaining ring.
Seals
Seals
