Miomare 360160 2007, Быстрый старт

Страница: 14 / 51

14 GB/IE
Note: If you turn off the water flow using the control
lever
6
then the fitting automatically switches to
bath filling.
Water-saving function
The cartridge
11
in this tap has an Eco-Click
function. This feature limits the water flow through
the tap. This means you can save up to 50 %
water (see fig. F).
Lift the lever
6
until you notice a slight resist-
ance. This resistance will cause a stop in case
of partial opening and will therefore simply
limit the flow of water.
If you want to increase the flow rate, exert slight
pressure on the lever
6
until you overcome
the resistance.
Setting the temperature limiter
The cartridge
11
in this unit has a temperature limiter.
This function is not activated in the factory (neutral
setting).
CAUTION! Change the temperature limiter
setting only after the tap has been installed.
Turn off the main water supply.
Remove the plastic cover
8
carefully by a
small flat screwdriver (see Fig. C).
Release the locking screw
7
by turning it anti-
clockwise using a hexagon key
13
.
CAUTION! Do not take the screw completely
out; just loosen it until the control lever
6
can
be easily taken off.
Take off the control lever
6
.
Loosen the cartridge end ring
9
by hand, then
screw off the cartridge locking ring
10
by using
a pipe wrench.
Now pull the setting ring
12
upwards with the
help of a screwdriver.
Note: Do not remove the cartridge.
Place the setting ring in the desired position as
shown in Fig. D.
Note: The setting ring
12
can limit the turning
angle of the handle, so that the amount of hot
water can be limited.
Tighten the cartridge locking ring
10
onto the
tap body
4
again by using a pipe wrench,
then tighten the cartridge end ring
9
by hand.
Place the control lever
6
back on to the tap
body
4
and tighten the locking screw by turn-
ing it clockwise using the hexagon socket
screw key
13
.
Press the plastic cover
8
into the opening.
Turn on the main water supply and check the
temperature limiter.
Maintenance and cleaning
Tap care and cleaning
Please note that sanitary fittings require special
care and attention. Therefore you should follow
the following advice:
Never use corrosive or alcohol-based materials
for cleaning, as these could damage the product.
Clean your fittings with clean water, mild detergent
and a soft cloth or leather only.
Screw out the mixer nozzle
4c
at regular intervals
and remove lime deposits or foreign bodies.
Non-observance of the above care advice can be
expected to result in damage to the surface of the
fittings. In this event your rights under the warranty
may be invalidated.
Information
Potability of mains water
Find out about the potability of your mains water
supply. Your local water authority or water supply
company will be able to inform you.