Minuteman Port A Scrub 12 Battery, Руководство пользователя и иллюстрированный список запасных частей

Страница: 11 / 32

MAINTENANCE
11
Port A Scrub 12 Battery
Do’s & Don’t’s
Do’s
Ÿ
Take adequate care to hold the machine firmly while
installing and removing the brush.
Ÿ
Ensure all parts are fitted properly before operation.
Ÿ
Take care when using a machine near the top of
stairs to avoid overbalancing.
Ÿ
Keep children and unauthorized persons away from
the machine when in use.
Ÿ
The batteries must be neutralized through an
approved secondary treatment facility prior to
disposal as waste.
Don’t’s
Ÿ
Don’t use where hazardous dust is present.
Ÿ
Don’t use in an explosive atmosphere.
Ÿ
Don’t pick up or use near flammable or combustible
fluids, hazardous dusts or vapors.
Ÿ
Don’t use to clean up any burning or lit debris
materials such as cigarettes, matches, ashes or
other combustible objects.
Ÿ
Don’t put any object into openings.
Ÿ
Don’t use with any opening blocked; keep free of
dust, debris and anything that may reduce airflow.
Ÿ
Don’t operate the machine when connected to the
mains electrical supply.
Ÿ
Don’t charge the machine with a damaged battery
charging lead or plug, or after the machine
malfunctions or is damaged in any way. Contact an
authorised Service Agent for repair or adjustment.
Ÿ
Don’t leave machine running unattended.
Ÿ
Don’t operate switches or touch the mains plug with
wet hands as this may cause electric shock.
Ÿ
Don’t pull or carry by the charger supply cord.
Ÿ
Never use excessive foaming or highly corrosive
cleaning solutions.
Ÿ
Do not dispose this device with unsorted waste.
Troubleshooting
Trouble Display Reason Remedy
Transport working knob is in bottom
position
Change to operating position
Main switch is on Off position Switch on the main switch
30 A fuse blown Replace fuse and check
Handle switch, tilt switch are
opened/faulty
Check switches
Battery low voltage Charge the battery
Motor over heated Wait for 20 minutes and restart
Worn brushes
Damaged lip on recovery tank
Broken lugs on recovery tank
Drum not revolving
Bridge fitted wrong way on machine or
springs broken
Fit bridge in correct way
Blocked jet
Blocked inline filter
Faulty pump
Blocked filter or faulty valve in solution
tank
Faulty pump micro switch
Damaged or broken pump On/Off cord Check cord
Plastic gear inside rim of drum sheared
Drum sprocket bearing seized
Build up of dirty hair etc. around bridge
springs
Plastic gears in gearbox stripped
Drum rubber sleeve loose on drum
LED blinks in RED
NA
NA
NA
Clean jet or inline filter
Replace brush, lip, lugs or springs
Clean drum and bearings and
remove dirt and build up
Machine fails to start -
no power
Brushes not rotating
Machine fails to pick up
water from the floor
Machine fails to spray
solution onto the floor
Drum not rotating
No LED Display