Minuteman M27000-00, Операционное обслуживание комплектующих и уход

Страница: 11 / 24

8
AFTER USE:
Turn machine off by pressing the “O” button on the control panel. Machine can be cleaned with a mild
detergent and a damp cloth. Batteries should be charged after each use or when the battery condition
meter shows a low charge. To recharge the batteries, plug the 36V charger into the recharge port
located at the bottom right rear corner of the machine. The recharge port has an interlock switch so
the machine can not be turned on when the batteries are being recharged. Once the meter on the
battery charger reads 0 amps, the batteries are recharged. This should take approximately 6 hours
if the batteries are completely discharged.
PAD INSTALLATION :
Using the “UP” arrow under “MANUAL”, raise the burnishing head to the full up position. Press the
“O” button on the control panel to turn the machine off. Remove the center cup locking device by
gripping on outer edges and turning clockwise. NOTE: center cup cannot be pulled out, it must be
unscrewed. After removing used pad, place new pad on pad driver assembly using outer flange to
center pad. Push center locking cup through pad and into pad driver assembly. The ratchet teeth on
the center cup will engage into the pad driver assembly and should be pushed in as far as possible.
If further tightening is needed, rotate the center locking cup counterclockwise.