Minuteman Lumina 20 M26036TD, Операционное обслуживание комплектующих и уход

Страница: 5 / 26

OPERATING INSTRUCTIONS
INSPECTION
Carefully unpack and inspect your burnisher for shipping damage. Each unit is tested and
thoroughly inspected before shipment; any damage is the responsibility of the delivery
carrier who should be notified immediately.
ELECTRICAL
This machine is battery operated and designed to operate on 36 volts DC (3) 12 volt
batteries.
BATTERIES
Burnishers are shipped with batteries. (3 required)
Part No. 956210 12V 210AH 20 Hr. Rate
We do not recommend mixing AMP hour capacities. Any alternate battery sets can be
used if they equal physical size and capacity. See next page for service and installation.
OPERATION
Before starting, familiarize yourself with the machine and its controls (see “Machine
Overview” and “Dashboard Control Panel” diagrams). To turn the machine ON, do the
following:
1. Make sure 20” high speed pad is used. Make sure the pad is installed on the
machine by following instructions under ”Pad Installation.”
2. Make sure that no battery charger is plugged into the recharge port.
3. Lift the red emergency disconnect button so it is in the up position.
4. Lower the pad driver assembly by pushing the pedal slightly outward on the
machine (unlock it), and then release it slowly.
5. Turn the key switch to the ON position. The pad driver will then slowly adjust itself
to the floor. Make sure the machine is set to move forward indicated by the light on
the dashboard control panel.
6. Place hands on the bails and squeeze the bail levers to start the operation of the
machine. Move forward in a straight line, check the reading on the Operating
Range Meter and make sure you are in the Green Zone.
7. Adjust the pad pressure as needed by turning the knob accordingly. (See Pad
Pressure Adjustments.)
8. Adjust speed as needed by turning the speed control knob accordingly.
5