4
FRONT WHEEL ASSEMBLY
Install front wheel bracket (1) to front housing using 5/
16 flat washer (2) and 5/16 nyloc nuts (3) and tighten.
Install front wheel (4) into front wheel bracket (1). Slide
nylon washer (7) onto clevis pin (5) and slide clevis
pin (5) all the way through front wheel bracket (1) and
front wheel (4). Slide second nylon washer (7) onto
clevis pin (5) and secure with hairpin (6).
FIGURE 1
FIGURE 3
HANDLE ASSEMBLY
Install handle assembly to blower, place rubber shim
(1) under handle strut (2) and place 5/16-18 x 2 bolt
(4) and 3/8 washer (3) into holes in handle strut (2)
and through frame (5) and tighten (not all the way) with
5/16 washer (6) and 5/16-18 nyloc nut (7). Place
handle (8) into handle struts (2) and align holes in
handle (8) and struts (2). Place 5/16-18 x 2 bolt (4)
and 3/8 washer (3) into strut (2) and handle (8), as
shown, and tighten with 3/8 washer (3) and 5/16-18
nyloc nut (7). Tighten bolts on strut/frame at this time.
Pull pull-rope handle (9) towards strut (2) and install
rope guide (10) around pull-rope. Place 1/4-20 x 2.5
bolt (11) through rope guide (10) and strut (2) and
tighten with 5/16 washer (6) and 1/4-20 nut (12).
THROTTLE CABLE ASSEMBLY
From operator position, the throttle cable can be
installed on outside of handle on right side or on inside
of handle on left side. To install throttle cable (1) to
handle (5), place #10 washers (3) between throttle
cable (1) and handle (5) as shown. Insert 10-24 screws
(2) through throttle cable (1), washers (3) and handle
(5) and tighten with 10-24 nyloc nuts (4). Mount snap
mount (6) and cable to handle (5). Place and tighten
cable tie (7) and cable around handle strut (8).
FIGURE 2
(Rear Wheel is Off
For Viewing Only)
Содержание HT0165B
