Minuteman ERS1500RTNC, Руководство пользователя

Страница: 5 / 15

7 6
INSTALLATION PLACEMENT
Output Power Receptacles
NEMA 5-15P
W/10 ft cord
Model # Input Power Plug
ERS1500RTNC
6-NEMA 5-15R Battery Backup & Surge
2-NEMA 5-15R Surge Only
REAR PANEL
1. RS232 Communications Port is for UPS monitoring and control.
2. USB Communications Port is for UPS monitoring and control.
3. The RJ11/45 are used for phone/fax/modem and network protection.
4. SNMP Card is for UPS monitoring and control (Included).
5. Battery Backup & Surge output receptacles for mission critical equipment.
6. Surge ONLY output receptacles for noncritical equipment.
7. Input power cord is for connecting to the Utility Power.
8. Input circuit breaker is for protection against an excessive overload.
This UPS is intended to be installed in a temperature/humidity controlled envi-
ronment that is free of conductive contaminants. DO NOT operate the UPS in:
extremely dusty and/or unclean areas, locations near heating devices, water
or excessive humidity, or where the UPS is exposed to direct sunlight. Select
a location, which will provide good air circulation for the UPS at all times.
Route power cords so they cannot be walked on or damaged.
Typical battery
life is 2 to 3 years. Environmental factors do affect battery life. High tempera-
tures, poor utility power, and frequent, short duration discharges have a nega-
tive impact on battery life.
CONTROL PANEL
1. AC normal and Boost/Buck mode LED (Green): Illuminates when the UPS
is in the AC normal mode and flashs when the UPS is in the Boost or the
Buck mode.
2. Battery mode LED (Yellow): Illuminates when the UPS is operating in the
Battery mode.
3. Fault LED (Red): Illuminates when the UPS has detected an internal fault.
4. On/Off/Test Button: To turn the UPS On/Off and to perform a ten-second
battery test.
CAUTION!
DO NOT USE THE MOUNTING BRACKETS TO LIFT THE
UPS. The mounting brackets are ONLY for securing the UPS to the rack.