3
CHARGER WIRING
1
2
3
4
5
6
Remove indicator light cap (fig. 2) and insert plastic lock nut through
indicator light assembly (fig. 3). Insert light end of assembly through
the opening on the machine’s back panel (fig. 4) and insert cover
over light housing (fig. 5). Re‐install indicator light cap and secure
onto back panel by tightening the retaining ring on the rear of the
panel (fig. 6).
NOTE: This can be done before or after the indicator light is
attached to the charger.
Attach indicator light wiring into the port as shown (fig. 7 & 8) and secure
connector onto the charger. Connect green connector onto green terminal
on the charger (fig. 9). Attach power cord and tighten screw to secure
power cord (fig. 10 & 11).
7
8
9
10
11
P/N 999081
