How To Install Mag Unit & Foot Step
Required Tools:
1x 5mm Hex Wrench
(supplied)
1x 10mm Spanner
(not supplied)
The Mag resistance unit and Foot Step now need to be
installed to the frame.
Attach the Foot Step onto the bracket on the Step-Bar first,
put the Mag unit over the Foot Step, then tighten both
brackets together with the pivot bolt (see Fig. H).
!
Overtightening the pivot bolt will cause the
Foot-Step to become inoperable.
Make sure you unscrew (loosen) the pivot
bolt by 1/4 - 1/2 turn once you completely
tightened it.
The Mag unit should be lowered towards the
ground slowly by its own weight at this point.
If the pivot bolt is too loose, the Mag unit
will drop quickly and you may be pinched
between the frame and Mag unit.
Adjust the tightening torque for the best
operation.
If the tire touches the plastic housing, it will damage them
both. Adjust the mag unit position horizontally to avoid this
problem.
To set the tire as close to center as possible, loosen the back
side screws and slide the mag unit sideways. Then re-tighten
both screws firmly.
If your tires size is
smaller than 26 x 1.50"
, you
will need to install the supplied Z-shaped Small Wheel
Adapter between the Mag unit and the base plate.
(The tire size is clearly indicated on its side wall.)
The direction of the Z-adapter is fixed so follow the
arrow printed on the top and make sure it's pointing
toward the front (toward the direction your bike goes
forward).
If the drive roller cannot reach the tire, make sure the
Z-adapter has been installed correctly.
Use the original cap head bolts for the Mount Base, and
use the supplied hex head bolts for the Mag unit. (Fig. J)
How To Use Small Wheel Adaptor
- 3 -
Step-Bar
Foot Step
Mag Resistance Unit
Pivot Bolt
Rear Tire
Hex Head Bolt
Round Head
Bolt
Z-Adaptor
(Fig. H)
(Fig. I)
(Fig. J)
Required Tools:
1x 5mm Hex Wrench
(supplied)
1x 10mm Spanner
(not supplied)
10mm Spanner
