Placing LR760 on Floor
Fully open the legs and place on a flat and horizontal
floor. (see Fig. D)
!
Make sure to open the legs until
the are fully extended.
Failure to do so will cause the
frame to be unstable.
Check that all 4 points are touching the
floor evenly. (see Fig. E)
If all 4 points are not touching the floor
evenly, the frame could be deformed and
cause damage to the trainer and possibly
your bike.
- 4 -
(Fig. D)
(Fig. E)
!
If the trainer remains unstable
after opening the legs fully, pull
sharply on the leg touching the
floor. This will re-adjust the pivot
bolt position.
LR760's coupling position is pre-adjusted in the factory to fit the 125mm standard rear hub width.
If it is too loose or too tight to your bike, or if you use different width of rear hub like a track race
bike, adjust the left side coupling as precisely as possible for maximum stability.
Please note there is no adjustment on the right side (hub clamping lever side) coupling.
Applicable Hub Width:
120 – 145mm
How To Mount Your Bike
!
The coupling cone shape is designed to fit the supplied quick release skewer perfectly.
We strongly recommend you to replace your rear wheel skewer with the supplied one.
We do NOT guarantee the stability while using LR760 with your own skewer.
!
If your bike's rear hub axle is NOT a quick release skewer type, but a hub nut type,
you don't need to use the supplied skewer.
The standard left side coupling bolt (UF-8S) is too short to hold the hub nut type axle.
You must replace it to the optional longer one "Extended Left Side Coupling Bolt for
Nut Type Hub (UF-8L)" for your safety.