- 4 -
!
3
!
1
2
!
Mag unit must be assembled on the left side
of HyperRimTrainer and the Assistant Roller
Unit on the right. Follow directions EX-
ACTLY. See diagram for accurate place-
ment. After deciding the height of the
pulleys tighten handle securely to avoid
damage to equipment and/or rider.
(see Fig. D)
Handle with care! Damage may occur if Mag unit is dropped.
Install the Assistant Roller unit to the right side of the frame, using
the same process as with the left-side Mag unit. Make sure the
assembly is secure and accurate. (see Fig. E)
Notes
The HyperRim is foldable and portable without requiring
disassembly of the Mag unit and assistant roller unit.
(Fig. E)
The Mag unit must be on the left side of the HyperRim’s frame,
and the assistant roller unit must be on the right side.
Both drive pulleys must be adjusted so as not to touch the tire.
You do not need to set this adjustment at this stage of the assem-
bly --- you can adjust it later, before use. Once you have set the
height of the pulleys, you must tighten the bolts firmly. If they are
loose, the assembly may break and/or damage your bicycle.
(Fig. D)
(Fig. F)
Place the bicycle's rear hub between the two
couplings, making sure that the quick-release
skewer (or hub nut) is not yet touching either
couplings. Then rotate the hub-clamp handles
clockwise to fix the rear hub. Tighten until securely
fastened, but do not overtighten.
Before installing your bicycle, rotate both hub-clamp handles counter-clockwise to create a wide
clearance between the couplings. (see Fig. F)
INSTALLING YOUR BICYCLE
