MINOURA DSX-2M Скачать руководство пользователя страница 2

MINOURA JAPAN

1197-1 Godo, Anpachi, Gifu 503-2305 Japan

Web:

 www.minoura.jp / 

Mail:

 [email protected]

Made in Japan

問い合わせ先

株式会社

 

箕浦

503-2305

 岐阜県安八郡神戸町神戸

1197-1

Phone:

 (0584) 27-3131

 / 

Fax:

 (0584) 27-7505

Web:

 www.minoura.jp / 

Mail:

 [email protected]

 DSX-2M の使い方/

How To Use DSX-2M

×

DSX-2M は、枠 ( 大 ) を下にして床に置きます。

(図 G)

Place the DSX-2M on the floor with the larger frame contacting 

the ground. (Fig. G)

!

枠 ( 小 ) が下になるような向き

(図 H ) では、十分な安定性を

確保できないため不適です。

Do not set the small frame 

as the base.

Doing so causes an im-

balance and your bike will 

not be stable while in the 

stand. (Fig. H)

枠の間にあるバネを通した樹脂キャップの上に、

静かに

車輪を下ろします。(図 I )

車輪の重みで枠 ( 小 ) が閉じていき、車輪を挟み込むことで自転車を自立させます(図 J )。【

最大荷重:10kg まで

Slowly place the wheel on the plastic caps between the frames 

gently

. (Fig. I)

The wheel's own weight will close the small frames to support the bike vertically (Fig. J). 

[Max Load: 10 kgs]

(図 I / Fig. I)

(図 J / Fig. J)

!

できるだけ多くのスポークが枠 ( 小 ) に接して保持されるように車輪を回して調整してください(図 A )。

2本程度では安定して保持することができません。そのため一部に対応不可能なホイールも存在します。

タイヤ幅が 3 インチを超えると、枠はスポークには届かず、タイヤのみで支えるようになります。

Allow the small frame to contact as many spokes as possible for maximum stability.

Contact with three or more spokes is essential to overall stability (Fig. A). Some fewer spoke 

wheels are not compatible.

Contact

!

車輪を落下させるような強い勢いで下ろさないでください。バネからボルトが抜けてしまいます。

もし抜けてしまったら、そのままにせず、ボルトを締め直してください。

Do not drop the wheel into the frames with force. Too much force may cause the bolt to come 

out from the spring. Do not leave in this condition and tighten the bolt again if it occurs.

4

反対側にも枠 ( 大 ) と枠 ( 小 ) を取り付けて、組み立ては完成です。

樹脂キャップの平面部は 13mm スパナを掛ける場所となります。

Install another set of small and large frames on the opposite 

side.

You can use the flat area on the plastic cap for attaching the 

13mm spanner when tighten.

13mm スパナ

13mm Spanner

(図 F / Fig. F)

!

ボルトはバネの内面をナット代わりにしてねじ込んで

使います。そのため強くねじ込みすぎると外れたり、

バネが変形してしまったりします。注意してください。

This product uses the inside of the spring as a nut.

Do not try to overtighten. The spring may be 

damaged or the bolt will come off.

(図 G / Fig. G)

(図 H / Fig. H)

In case of over 3-inch tire width, it 

becomes impossible to reach the 

spoke and will be supported by tire 

only.

Отзывы: