Setting Up The Bike Cradle
1
(Fig. C)
Install the Cradle Hook behind the Alloy Stay. (see Fig. C)
Adjust the distance and angle of the hooks to suit the bike frame.
2
Place the Angle Adjust Plate onto the Lower Support, then put the
Alloy Stay on it.
Fix these three parts firmly with the supplied M6x20 bolt in the upper
hole. (see Fig. D)
Screw the supplied M6x15 bolt in the lower hole, but you don't need
to tighten it so firmly at this moment.
(Fig. D)
(Fig. E)
(Fig. F)
3
4
Disassemble the supplied stainless band clip by removing the bolt.
Wind the Stainless Band around the pole, insert the end of band into
the gap between another end and the Rectangle (not square) Nut.
Holding it in place, put the Plastic Bracket and assembled bike cradle
together, then tighten them down with the bolt you removed earlier.
(see Fig. E)
!
The Stainless Band must ONLY be used on the
upper side of the bike cradle. Do NOT use it on the
bottom position of the bike cradle. (see Fig. F)
Tighten the bolt on the Stainless Band firmly.
Failure to do so may cause the bike to slip down
the pole.
Alloy Stay
Cradle Hook
M6x20 bolt
M6x15 bolt
Stainless Band
Plastic Bracket
!
Stainless Band Assy
Just putting onto the pole
Installing Your BikeTower In Your Room
Set the BIKE TOWER between the ceiling and the floor.
First, put the Upper Rubber Cup against the ceiling, and push the Pole
up to contact and shorten the inside spring.
Next, line up the Bottom Rubber Cup until the Main Pole is vertical.
Once you line up the top and bottom, pull down the Main Pole softly.
(see Fig. G)
(Fig. G)
1
2
- Page 3 -