HOW TO INSTALL
1
First, cover both Fixing Plates from the outside of roller frame. Insert Knob Bolt through
the hole on the roller frame where the front roller can be installed, and then tighten with Sub
Fixing Plate temporarilly.
2
Place Frame Reinforcement Plates just on roller frame, and tighten them with Cap Bolts.
Frame Reinforcement Plate will disperse the load from the bike to roller frame and control
the movement of Frame, so that you should stick them onto roller frame.
3
Remove the front wheel from the bike, and fix the fork end onto Skewer.
You must tighten Skewer firmly in order to prevent from any troubles caused by looseness.
4
When you place the rear wheel between the center roller and rear roller, make sure that the
rear wheel touches to both rollers at same time.
When the rear wheel touches to only one roller even if you adjust the angle of Frame, your
install position is wrong. Install Knob Bolt again to the other hole.
Finally, tighten Knob Bolts firmly.
MORE INFORMATIONS
Contact:
MINOURA CO.,LTD. JAPAN
1197-1 Godo Anpachi Gifu 503-23 JAPAN
Phone: (+81) 584-27-3131 / Fax: (+81) 584-27-4258
E-mail: [email protected] / [email protected]
RESOLUTION DIAGRAM
