4. Place the camera in the case face down as shown.
3. Place a packet of desiccant in the case as shown.
• Desiccant helps prevent condensation. In cold environments or underwa-
ter, heat from the camera can cause condensation to form on the internal
surfaces of the case. Condensation may prevent recording and can dam-
age the camera.
• The packet should be flat and even.
• Do not to place the desiccant so that it covers the camera flash.
• The desiccant should be replaced after every use.
• Packets of desiccant weighing 1g to 2g can be used. They can be pur-
chased at a camera store or diving shop.
PREPARATIONS
When installing the camera, take care to keep dirt from entering the
Marine Case and interfering with the watertight seal. To reduce condensa-
tion from forming on the inside of the case during use, load the camera or
change the battery and memory card in a dry environment.
Confirm nothing is caught in
the door and the O ring is seat-
ed properly.
PREPARING THE CAMERA
Refer to the camera’s instruction manual for detailed instructions.
1. Remove the strap.
• The camera strap may catch in the case’s door when it is closed causing
leaks.
2. Insert a fully-charged battery and memory card.
• Using a new battery is recommended.
• Confirm there is enough storage space on the memory card to record
your images.
INSTALLING THE CAMERA
Inspect the O ring, O-ring channel, and O-ring contact surface (See HANDLING
PRECAUTIONS). The case should be completely dry and free of dirt, dust, or
other foreign matter.
1. Turn the mode switch on the camera and case to the recording-mode posi-
tion. The mode switch on the back of the case is turned to the left.
• The mode switches must be aligned on the camera and Marine Case
before the case is closed otherwise the switch may be damaged or the
camera operation impaired.
Recording mode
Playback mode
The position of mode switch
2. Push the lock in the direction of the arrow as shown (A). The latch will pop up
unlocking the case.
•Do not exert great force on the latch when opening. The latch may be dam-
aged.
5. Close the back door and press down firmly to seal it. Push the latch into its
locked position until it clicks.
When closing the case,
the latch must be positioned as shown.
7. Attach the strap to the strap eyelet as shown.
• The length of the strap can be adjusted (A).
A
6. Turn on the camera and confirm the operation of the case buttons and
switches.
A
