3
3-10
Setting up the Pi5500 from a Windows Computer
Ignore EOF Character
—Available only if Enable Parallel Port is selected, this option
specifies that the Pi5500 should ignore end-of-file (EOF) messages. Select this check
box to print PostScript files in binary format (not ASCII); under normal
circumstances, the option should be cleared. When this option is selected, the Pi5500
uses the parallel port timeout value to determine when the end of the file has been
reached.
Parallel Port Timeout (seconds)
—Available only if Enable Parallel Port is selected, this
setting determines how long the Pi5500 waits without receiving data from the parallel
port before deciding that the current job is complete. Until the timeout, the Pi5500
cannot receive new jobs through the parallel port, but it can continue to receive
network print jobs.
Token Ring (Port Setup)
Enable Token Ring
—Select if the Pi5500 is connected to a Token Ring network.
Maximum Frame Size
—Select the maximum frame size recommended by the network
administrator at your site. If you are uncertain of the setting to use, select the default
value (4202).
Transmission Speed
—Select Auto Sense if your network environment is mixed, or
select the speed (4 Mbps or 16 Mbps) of the network to which the Pi5500 is attached.
Enable Source Routing
—Select if your network supports source routing.
Request All Routes
—This option is active only if you enabled Source Routing.
Select if you want the Request packet to travel to its destination by all routes.
Respond All Routes
—This option is available only if the previous option is not
selected. Select if you want the Response packet to return by all routes to the
originating computer.
