Minolta Di620, Руководство пользователя, Страница: 15 / 466

G-10
1155SBG0300A
■
Installation Site
To ensure safety and utmost performance of the copier, the copier should NOT be
used in a place:
●
Where it will be subjected to extremely high or low temperature or humidity.
● Which is exposed to direct sunlight.
●
Which is in the direct air stream of an air conditioner, heater or ventilator.
●
Which puts the operator in the direct stream of exhaust from the copier.
●
Which has poor ventilation.
●
Where ammonia gas might be generated.
●
Which does not have a stable, level floor.
●
Where it will be subjected to sudden fluctuations in either temperature or humid-
ity. If a cold room is quickly heated, condensation forms inside the copier, result-
ing in blank spots in the copy.
●
Which is near any kind of heating device.
●
Where it may be splashed with water.
●
Which is dirty or where it will receive undue vibration.
● Which is near volatile flammables or curtains.
■
Power Source
● If any other electrical equipment is sourced from the same power outlet, make
sure that the capacity of the outlet is not exceeded.
●
Use a power source with little voltage fluctuation.
●
Never connect by means of a multiple socket any other appliances or machines
to the outlet being used for the copier.
●
Make the following checks at frequent intervals:
•
Is the power plug abnormally hot?
•
Are there any cracks or scrapes in the cord?
•
Has the power plug been inserted fully into the outlet?
•
Does something, including the copier itself, ride on the power cord?
●
Ensure that the copier does not ride on the power cord or communications cable
of other electrical equipment, and that it does not become wedged into or under-
neath the mechanism.
■
Grounding
To prevent receiving electrical shocks in the case of electrical leakage, always
ground the copier.
●
Connect the grounding wire to:
•
The ground terminal of the outlet.
•
A grounding contact which complies with the local electrical standards.
●
Never connect the grounding wire to a gas pipe, the grounding wire for a tele-
phone, or a water pipe.
Use an outlet with a capacity of 115/120/127V, or 220-240V.
3 PRECAUTIONS FOR INSTALLATION