MINOLTA-QMS PagePro 4100GN, Руководство пользователя

Страница: 29 / 189

2 Unpacking, installing and setting up the printer
2-12 PagePro 4100GN
Connecting the power cable
Only use the power cable supplied with the printer!
The laser printer requires a power supply with minimal voltage and
frequency fluctuation. If necessary, ask an electrician for advice.
✔ Power supply: 120-127 V at 50-60 Hz / 220-240 V at 50-60 Hz
✔
Voltage fluctuation: 120 V -10%, 127 V +6% / 220-240 V ± 10%
✔ Frequency fluctuation: Within 3 Hz
1
Make sure that the printer’s power
switch is in the "0" (OFF) position.
2
Insert the plug on the end of the
power cable (supplied) into the
power socket of the printer.
3
Insert the other end of the power
cable into a power socket.
CAUTION
Using the wrong power cable may lead to a short-circuit situation!
The use of a power cable of inadequate cross-section can lead to over-
heating of the cable.
➜ Only use an extension cable which has a higher rating than the current
consumption of the printer.
➜ Only use cables with a ground connection.
➜ Always observe the relevant local regulations regarding the
connection of electrical equipment to the mains network.