12 | minnkotamotors.com
©2018 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE TERROVA
k. Put a 1/4-20 x 2" (Item #1) screw in each of the
drilled locations. The screw should pass through the
Base Extrusion and the boat deck. If the rubber
washers (Item #4) are used, they should sit between
the Base Extrusion and boat deck. Make sure to
secure the motor with screws on each side of the
Base Extrusion.
l. Place a Flat Washer (Item #2) and then a Nylock Nut
(Item #3) at the end of each screw as shown and
secure. Make sure all hardware is secure.
ITEM(S) NEEDED
#4 x 6
#3 x 6
Screw
Rubber Washer
Boat Deck
Nylock Nut
Flat Washer
m. Replace the Right Sideplate.
n. Swing the Left Sideplate back into its correct
position on the Base Extrusion.
Right Sideplate
Left Sideplate
Base Extrusion
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may help
prevent seizing.
7
8m
8
8n
#1 x 6
#2 x 6
