minnkotamotors.com | 2
©2016 Johnson Outdoors Marine Electronics, Inc.
INSTALLATION
a. Place the motor in the stowed position.
b. Unthread the Aluminum Rod
(Item #4)
from the
Stabilizer Bracket
(Item #8)
by removing the Top
Bumper
(Item #10)
and unscrewing the bracket.
Also remove the Bottom Bumper
(Item #2)
. Keep
the Jam Nut
(Item #6)
in place.
c. Determine the desired orientation of the
Stabilizer Kit to attach it to the bottom of the
Bowguard/Steering Module.
d.
For the Fortrex
, put the 5/16” Cap Screws
(Item #14)
through the Stabilizer Bracket and
the mounting holes on the Bowguard. Secure the
5/16” Cap Screws with the 5/16-18 Nylock Nut
(Item #12). The Nylock Nuts fit into a hex pocket
on the inside of the Bowguard behind the spring.
Secure with a 1/4” Allen Wrench. Tighten to
10 ft lbs.
e.
For the Ultrex
, place a Lock Washer
(Item #16)
on the two 5/16” Cap Screws
(Item #14)
.
Use the 5/16" Cap Screw to secure the
Stabilizer Bracket to the Steering Module using
a 1/4" Allen Wrench. Tighten to 10 ft lbs.
1
2
NOTE:
The kit can be installed on the left
or right side of the Bowguard/Steering
Module.
NOTE:
The two 5/16-18 Nylock Nuts (Item #12) are
not used when installing on the Ultrex.
NOTE:
The two Lock Washers (Item
#16) are not used when installing on the
Fortrex .
Top Bumper
Stabilizer
Bracket
Bowguard
Steering Module
Cap Screw
Nylock Nut
Lock Washer and
Cap Screw
Stabilizer
Bracket
Stabilizer
Bracket
Jam Nut
Aluminum Rod
Bottom Bumper
ITEM(S) NEEDED
ITEM(S) NEEDED
#14 x 2
#12 x 2
#16 x 2
#10 x 1
#8 x 1
#4 x 1
#6 x 1
#2 x 1
Fortrex
Ultrex
