MINN KOTA 1854035, Руководство пользователя

Страница: 12 / 24

a. Slide the Top Plate attached to the motor back onto
the Bottom Plate that was mounted to the Bow of
the boat. Secure with the Lock Washer and Tension
Screw Knob. Always check the Tension Screw Knob
and tighten when needed.
NOTICE:
Lock your motor
to help prevent theft.
Lock Washer Lock Washer
Tension Tension
Screw Knob Screw Knob
Bottom Bottom
Plate Plate
Bow Bow
Top Plate Top Plate
For warranty information, please visit minnkotamotors.com .
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001 121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
minnkotamotors.com
©2022 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Part #2374914 Rev L 12/22 ECN 43066
1
g. Reposition the Bottom Plate over the drilled holes.
Ensure that the U Shape points inboard. Insert a
Mounting Bolt (Item #18) into each of the four drilled
locations. The Bolts should pass from the top down,
through the Bottom Plate and into the boat deck.
h. Place a Fender Washer (Item #12) and a Nylock Nut
(Item #16) on the end of each Bolt, then tighten with
a 7/16” Box End or Open End Wrench. Make sure all
hardware is secure.
Mounting Bolt Mounting Bolt
Boat Deck Boat Deck
Bottom Plate Bottom Plate
Fender Washer Fender Washer
U Shape U Shape
Nylock Nut Nylock Nut
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high-speed installation tools.
Wetting the screws or applying an anti-seize may help
prevent seizing.
#18 x 4 #12 x 4 #16 x 4
Inboard Inboard
Outboard Outboard
ITEM(S) NEEDED
4
NOTICE:
The mounting surface for the Bottom Plate
must be completely flat. Rubber Washers can be used to
shim the Bottom Plate flat before hardware is tightened.
Completing the Installation