8
HANGING THE FAN-STANDARD CEILING MOUNTING
WARNING:
All of the parts, hardware and components such as the hanger bracket and hanger ball have been
provided for your safety and the proper installation of your new ceiling fan. The use of other parts, hardware or
components not supplied by Aire with the fan will void the Aire Warranty.
REMEMBER
to turn off the power. Follow the steps below to hang your fan properly:
Step 1. Secure the Hanger Bracket to the ceiling outlet box using the screws provided with your outlet box in
conjunction. (Fig. 5)
Step 2. Loosen the two Set Screws and remove the Hitch Pin and Lock Pin from the coupling located on the top of the
Motor Assembly. (Fig. 6)
Step 3. Remove the Hanger Ball from the Downrod Assembly by loosening the Set Screw and removing the Cross Pin.
(Fig. 7)
Step 4. Carefully feed fan wires up through the downrod. (Fig. 8) Thread Downrod into the Coupling until the holes are
lined up and secure with the Lock Pin and Hitch Pin previously removed, tighten Set Screws. (Fig. 10)
Step 5. Installing the canopy cover to the canopy. (Fig. 9)
Step 6. Slip coupling cover, canopy ring and canopy onto downrod. (Fig. 10) Carefully reinstall hanger ball onto rod being
sure that cross pin is in correct position, set screws are tighten and wires are not twisted.
Step 7. Lift the Motor Assembly and place the Hanger Ball into the Hanger Bracket. Rotate the Motor Assembly as needed
until the check groove from the Hanger Ball rests firmly over the registration tab from the Hanger Bracket. (Fig. 11)
FIG. 9
FIG. 5
OUTLET BOX
HANGER BRACKET
DOWNROD
SUPPLY
WIRES
CROSS PIN
HANGER
BALL
DOWNROD
HITCH
PIN
LOCK
PIN
SET SCREWS
SET SCREW
FIG. 6
FIG. 7
FIG. 8
FIG. 11
REGISTRATION
SLOT
FIG. 10
DOWNROD
CANOPY
CANOPY
CANOPY
RING
CANOPY
COVER
HITCH PIN
LOCK PIN
COUPLING
COVER
SET SCREWS