Minka-Aire Mesa F565, Инструкция по эксплуатации

Страница: 12 / 13

T
ROUBLESHOOTING
Solution Solution
Check to make sure the wall switch is turned on.
Check circuit fuses or breakers.
Caution! Make sure the power is turned off before performing Caution! Make sure the power is turned off before performing
the following steps; the following steps;
Remove canopy and check wire connections.
If using a remote controlled fan; check to see that the deep
switches from transmitter and receiver are set to the same
frequency code.
Check wall control transmitter connections (if applicable).
This is caused by interference, change the code frequency from
the transmitter and receiver. Any code combination will
operate the fan or light (remote controlled fans only).
Allow a 24-hour "break in" period. Most noises associated with
a new fan will go away during this time.
Make sure all blade attachment screws are tight.
Make sure outlet box is secured to building structure, if
necessary use the wood screws provided to further secure outlet
box to joist.
Make sure hanger bracket is secure to the outlet box, screws are
tight.
NOTE: NOTE: All blade sets are grouped by weight. Because wood
and plastic blades vary in density, the fan may wobble even
though blades are matched.
Make sure all blade attachment screws are tight.
Make sure outlet box is secured to building structure, if
necessary use the wood screws provided to further secure outlet
box to joist.
Make sure hanger bracket is secure to the outlet box, screws are
tight.
Use the balancing kit provided if the wobble is excessive
(follow instructions included with balancing kit)
Symptoms Symptoms
Fan Will not Start
Fans/Light Turn On
and Off Unexpectedly
Fan Sounds Noisy
Fan Wobble