1.
Steering reverse switch - Changes direction of steering
servo.
2.
Throttle reverse switch - Changes direction of Throttle
servo (gas car).
3.
Power LED – Lights red when transmitter is turned on.
4.
Signal LED – Lights green when voltage is good.
5.
BIND button – Used when binding transmitter and re-
ceiver.
6.
Steering trim dial – Adjusts neutral on steering servo.
7.
Throttle trim dial – Adjusts neutral on speed control or
throttle servo (Gas models)
8.
Steering Dual Rate dial – Adjusts the amount of steering
in the model.
9.
Power switch.
Binding the Transmitter and Reciever
Normally the binding procedure is done at the factory but if
you for some reason loose signal or change to a new receiver
you have to re-bind the equipment.
•
Insert the supplied binding loop into channel BIND / CH3
of the receiver.
•
Connect the battery and turn on the power of the re-
ceiver. The receiver LED will start flashing.
•
Press and hold the transmitter BIND-button (located on
the panel) and at the same time switch on the power.
•
If the binding is successful the LED on the receiver should
become solid in a couple of seconds.
•
Take out the Binding loop from the receiver and you are
good to go.
Installing the Battery Pack
You need to insert the battery pack in the open section for the
battery. Use the strap provided to place on top of the battery
and then use the 2 retaining clips to secure the battery.
Once fastened and secured please connect the battery plug
into the speed controller plug noting correct polarity. Red to
red, black to black.
Turn the Power On and Off
Always turn on the transmitter first and then turn on the
power in the model and always turn off the model first before
you turn off the transmitter. In this way you secures that the
model never has power without being connected to its trans-
mitter. A model with the power on without connection to the
transmitter could drive away on its own without control.
Turning the power on
•
Turn on the transmitter Power switch and the LED power
and battery indicator will light up.
•
Turn on the power switch in the model. The speed con-
troller is factory set and will be ready to use. The LED on
the receiver will turn solid. If the LED flashes you have no
connection and have to do the binding process.
Turning the power off
•
Turn off the model Power switch.
•
Turn off the transmitter Power switch.
•
Disconnect the battery connector from the model.
Trim Setup
Steering Trim
If the front tires are not pointing straight forward with the
transmitter on and the steering wheel in neutral, adjust the
steering trim. If needed, make fine adjustments with the
steering trim whilst driving the vehicle.
If the front tires are straight no adjustement is needed.
