ENGLISH
ENGLISH
10
11
4.
Crank the engine within 30seconds.
5.
If the vehicle does not start after 5 to 8 second, stop and try again.
6.
After the vehicle is started, remove clamps from car battery.
7.
Recharge the jump starter.
E. PARTS LIST:
G. TROUBLESHOOTING:
F. SPECIFICATIONS:
#
Parts Name
Quantity
1
Host
1
2
Wall adaptor
1
3
Switch cable
1
4
User Manual
1
Problem
Possible Causes
Likely Solutions
Alarm rings and LCD
display shows
“OUTPUT LOCKED.
The device fails to
jump start vehicle.
LCD display is blank,
shows no message
LCD display shows
“OUTPUT LOCKED”
and keeps winking.
Battery Clamps are connected
wrong or there is a short circuit.
1) Battery clamps are out of work.
2) Jump starter is flat
3) Jump starter is damaged.
1) USB output or 12V DC output
may be overload or a short circuit
may occur, accordingly the device
is locked for safety.
2) The jump starter is empty
Self-protect after 3 operations
within short time.
Disconnect clamps immediately.
Correct Clamp connections
before resume the operation.
1) Repair or replace
clamps or cord.
2) Recharge the jump
starter to full.
3) Please check with the
local dealer. *Service must be
performed only by a qualified
technican.
1) Press Main Power Button
to unlock the unit and
esume operation.
2) Recharge the jump starter
Leave the jump starter alone
2 minutes before resume the
operation.
Dimension:
292 x 233 x 79mm
Weight:
2700g
Starting Current:
12V 600A; 24V 300A
Peak current:
12V 1200A; 24V 600A
BatteryLithium Iron Phosphate:
35,000mAh
12VDC Power Output:
10A
USB Output:
5VDC, 2A x 1 and 1A x 1
LED Flash light:
3W/250 Lumens
Fully Charging Time:
About 7 hours