Minibar Systems
SmartFridge 50 Full Glass Door User’s Guide
100-127V~60Hz: 50-G-AC-ET
220V-240V~50/60Hz: 50-G-AC-ET
SmartFridge 50 Full Glass Door User's Guide_Rev-5.doc
Page 6
QUICK COOL
– The SmartFridge will chill until the temperature reaches 37°F/1°C. You can enter this mode
by pressing the QUICK COOL button from ON or SNOOZE modes. The green LED will flash until QUICK
COOL is complete. Upon completion, the SmartFridge will return to the ON mode. The default temperature
is 37°F/1°C ± 1°C.
DEFROST
– The SmartFridge shuts down the compressor every 12 hours for 30 minutes to allow for frost
and ice built up on the chiller plate to melt. This is an automatic function that runs all the time unless in STOP
and FAILURE modes.
FAILURE
–
-
If the SmartFridge detects a temperature probe malfunction, the LEDs and display flash, displaying “EL”
or “EH.” Once the problem is fixed, the unit will return to the previous mode.
5.4
Special Features
-
To reduce thrashing of the compressor, there is a 3-minute turn-on delay.
-
Opening the door from OFF mode will switch the SmartFridge to ON mode.
-
The display will turn off after 10 seconds of non-use.
-
A GONG (Go/No Go) test is executed at power up. All the LEDs flash, and all the segments rotate on the
display including the decimal points. The temperature probe is checked for a valid range or connection.
-
If the temperature probe is out of range or not connected the SmartFridge will go to a FAILURE mode.
-
The default operating temperature is 37°F/3°C for the solid door model; 41°F/5°C for the glass door
model. You can change the default temperature by pressing the SNOOZE and QUICK COOL buttons at the
same time and holding for three seconds. Both LEDs will turn on signifying you are in the Temperature Set
mode. The current temperature setting saved in FLASH will be displayed. Pressing the SNOOZE button will
increase the temperature, pressing the QUICK COOL button will decrease temperature. Press the SNOOZE
and QUICK COOL buttons at the same time to exit Temperature Set mode. At this time the new
temperature setting will be saved in FLASH. Minimum temperature allowed is 37°F/1°C and maximum is
48°F/9°C.
-
The default temperature format can be switched between °F and °C by pressing and holding the QUICK
COOL button for three seconds.
