Page 31 of 50
AN-49-003 Rev.: E (September 6, 2019) M175867 (R95153) File: AN49003.doc
This document and its contents are the property of Mini-Circuits
3.7
Pulse Mode:
This screen (
) allows you to specify a pulsed RF signal in one of several formats selected by clicking
on the desired option of the Pulse Source listed in the upper left corner of the screen.
Figure 3.7a
Pulsed RF initial window
Pulse Source
– Selects the type of pulsed RF signal to generate (see below for explanation).
CW
– Begins generating a CW RF signal at the specified frequency and power levels.
OFF
– Stops RF output, same as clicking on the ‘RF ON/OFF’ button on the main screen.
Run Pulse
– Begins generating a pulsed RF signal according to the conditions specified.
Figure 3.7b
Pulsed RF, signal plot
