Page 15 of 39
AN-49-005 (December 23, 2019) M176825 (R95497) File: AN-49-005(J).doc
This document and its contents are the property of Mini-Circuits
5V AC/DC
wall power adaptor
Connect to PC’s
Serial port
MUSB-CBL-3+ or Eqv.
Connect to
User system
D-SUB9-MF-6+
or Eqv.
Connect to
User system
Figure 2.3.2:
RUDAT RS232 setup option1
2.3.3
RS232 Control (RUDAT & ZVVA) with power via D-Sub Pin#1
This option is supported in the following units:
Model P/N
Serial Number
RUDAT-6000-30
11405010010 and greater
RUDAT-6000-60
11407150001 and greater
RUDAT-6000-90
11403230000 and greater
Other RUDAT models All serial Numbers
ZVVA models
All serial Numbers
This option requires the use of an RS232 port wired to 5V
DC
at Pin#1
-Connect D-Sub9 cable between attenuator unit D-Sub port and custom RS232 port.
-Note the Indicator lights up.
-Connect attenuator input and output SMA ports to your system.
Note:
For RUDAT-13G-xxx verify pins 7-9 in the D-Sub connector are not connected to
any active signal as this may disrupt proper operation.
Figure 2.3.3:
RUDAT RS232 setup option 2
