3.3
Changing Ethernet Settings Using the GUI Program
3.3.1
Factory default settings for
RCDAT and RC4DAT models are Dynamic IP
(DHCP) using Port 80 (see Figure 3.3.2). Changing these settings can be done only via USB
control. In the USB control GUI (see
section 3.1.3
) click on the Ethernet Settings button.
Figure 3.3.1: USB Control
3.3.2
The Ethernet Settings screen will
open showing the current configuration.
Figure 3.3.2
shows the factory default of the programmable attenuators. If these settings are
appropriate for your local network then you do not need to access the setup before connecting
the attenuator to the network and can connect to the attenuator via Ethernet as described in
section 3.1.5
.
Figure 3.3.2: Ethernet Settings screen (showing factory default state)
9
4
2
6
11
1
3
7
10
12
5
8
Figure 3.3.1: USB Control
Page 23 of 31
AN-49-005 Rev.:
D
(August 7, 2016) M156027 (R90553) File: AN-49-005(D).doc
This document and its contents are the property of Mini-Circuits
