CLEANING YOUR TAN.HANDY SPRAY TAN GUN
CLEANING YOUR TAN.HANDY FILTER
The Tan.Handy Filter is located at the front of the unit as pictured below.
IMPORTANT!
Please disconnect from supply circuit before cleaning or
removing
fi
lters.
SPRAYING SIDE TO SIDE
ACROSS THE BODY
SPRAYING UP & DOWN
THE BODY
SPRAYING SIDE TO SIDE ACROSS THE BODY
Set the nozzle fan ‘Horizontal ’. This spray
pattern is perfect for spraying side to side
ie. le
ft
to right – right to le
ft
across the body.
SPRAYING UP & DOWN THE BODY
Set the nozzle fan ‘Vertical’. This spray
pattern setting is perfect for spraying up
and down, top to bottom of the body.
5. OPERATION
POWER ON : AIRFLOW
Turn the device ‘on’ by pressing the on switch. The Tan.
Handy has an intelligent Air-Smart Switch, so with just
turning it on, it controls the air
fl
ow for the perfect spray.
This creates
fl
awless spray tanning results every time.
6. SPRAY TAN TECHNIQUE
Holding the Tan.Handy approximately 10 -15cm (4 - 6”) away, start at the feet
and work up, using sweeping, steady motions, keeping the Tan.Handy moving
at all times as holding in one spot too long may result in dark spots.
If a dark spot occurs, smooth our immediately with the Application Mitt and
continue spraying. Work your way up the entire body, making sure to get
complete and even coverage. Avoid spraying directly your heels, knees, and
elbows to prevent deeper tanning in these areas.
For best results refer to MineTan’s A Picture Perfect Finish, How to Spray Tan
recommended spray tan poses’ for the perfect spray tan.
7.
Allow tan to dry before wearing clothing. Follow your preferred product
instructions for best results when applying the spray tan. Avoid swimming or
exercising, for the next 24 hours.
Clean your Tan.Handy a
ft
er each use. Do not use any alcohol, acetone, petrol or
any abrasive-cleaning agents.
1. Remove the spray tan gun from the Tan.Handy Mini Turbine.
2. Unscrew the cup from the Spray Gun and empty any un-used solution from
the cup.
3. Rinse the empty solution cup with warm water until clean and then
fi
ll the
cup about
¼
full of warm water.
4. Insert the cup and screw tightly, back into the spray tan gun and re-connect
to the mini-turbine.
5. Turn on your Tan.Handy and direct the spray tan gun into the sink and spray
the clean water through until the cup is empty. This will clean through the
needle and out to the spray-pattern nozzle.
8. Disconnect the spray tan gun from the mini turbine and unscrew the cup.
9. Wipe all areas dry with a cloth including the cup and Tan.Handy ready for
the next use.
IMPORTANT!
You must not submerge the spray gun under water. If
your Tan.Handy has excess spray solution, wipe down with cleaning
wipes. Alternately you can use a smooth cloth (avoid anything
abrasive) with a general glass cleaner to maintain the gloss
fi
nish.
3. Please leave to dry completely.
1. Remove the
fi
lter cover from the
mini turbine.
2. Wash under cold water. Do not
use detergents to clean the
fi
lter.
STORAGE
USING YOUR TAN.HANDY
MANUFACTURER’S GUARANTEE
1.
Always allow the Tan.Handy to cool down before storing away.
2.
When the Tan.Handy has cooled down, fold the power cord in the same
way as it was
fi
rst delivered in its packaging. Do not wrap the power cord
around the Tan.Handy as this can strain the cord and cause premature
power cord failure.
1.
Prior to tanning, make sure you exfoliate your skin in the shower using the
Exfoliating Mitt. Exfoliating allows for a smoother application as well as helping
the tan to fade evenly.
2.
Be sure skin is completely clean and dry. Do not apply any moisturisers, oils,
deodorants or perfumes prior to use. Waxing or shaving should also be done
at least 24 hours prior to tanning.
3.
Put hair up and cover with plastic cap, remove all jewelery.
4. SETTING SPRAY PATTERN
Adjusting the spray-pattern nozzle of your Tan.Handy to suit your preferred style of
spray tanning.
All Tan.Easy Pro Tools devices are individually tested before leaving the factory.
However in the unlikely event of the product providing defective due to faulty
workmanship or materials, then, at its sole discretion, Tan.Easy Pro Tools will repair
or replace the product at no charge with an identical or equivalent product
within one year from the original date of purchase. A replacement product
assumes the remaining warranty of the original product, which ever provides
longer coverage for you. When a product is exchanged, any replacement item
becomes your property and the replaced item becomes property of Tan.Easy
Pro Tools.
To claim under this guarantee please visit
‘taneasyprotools.com/warranty-and-
guaranty/’
and follow the on-screen instructions to complete your return. Please
ensure that you include a proof of purchase with any returned product.
This guarantee only applies to genuine Tan.Easy Pro Tools purchased through
Tan.Easy Pro Tools approved stockists, and does not cover products repaired or
served by anyone other than a Tan.Easy Pro Tools personnel and Tan.Easy Pro
Tools representatives. Note that this guarantee may be invalidated were serial
numbers or identi
fi
cation have been erased, damaged or modi
fi
ed. This does
not a
ff
ect your statutory rights.
The guarantee does not include;
1. Damage caused by misuse, improper treatment or violent usage.
2. Damage caused by failure to comply with these instructions for use.
3. Damage caused by connecting this appliance to the incorrect voltage
4. Damage caused by connecting accessories supplied by other manufacturers.
5. Minor faults, which do not signi
fi
cantly a
ff
ect the value of the device or its
e
ff
ective use.
Australia Only.
Our goods come with guarantees that cannot be excluded under the Australia
Consumer Law. You are entitled to a replacement or refund for a major failure
and for compensation for any other reasonably foreseeable loss or damage. You
are also entitled to have the goods repaired or replaced if the good fail to be of
acceptable quality and the failure does not amount to a major failure.
PRECAUTION
IF YOUR SKIN IS VERY SENSITIVE IT IS ADVISABLE TO CONDUCT A PATCH TEST A
MINIMUM OF 12 HOURS PRIOR TO THE APPLICATION OF THE TAN.
IMPORTANT
WASH MINI COMPRESSOR FILTER WITH
WATER AT LEAST EVERY 6 MONTHS
HANDY TIP
ANY SPRAY TAN SOLUTION WILL LAST LONGER IF
STORED IN THE REFRIGERATOR AFTER OPENING
