2
Safety instructions
2.1
General safety information
-
The equipment may only be used as intended for printing tasks.
-
Observe the operating limits of the device.
-
Position the device so that the power plug is freely accessible and the power cord
does not present an obstacle or trip hazard.
-
Unplug the power cord from the mains supply before cleaning.
-
Make sure that no liquid enters the equipment.
2.2
Incoming goods inspection
The shipment must be checked for completeness. A visual inspection must be performed
to determine if the shipment has been damaged. If there are grounds for a complaint, this
must be brought to the attention of the delivery company immediately. A Minebea Intec
sales or service point must be informed.
The shipment must be checked for completeness. A visual inspection must be performed
to determine if the shipment has been damaged. If there are grounds for a complaint, this
must be brought to the attention of the delivery company immediately. A Minebea Intec
sales or service point must be informed. Visit our website http://www.puroscales.com or
contact your dealer.
2.3
Before operational startup
NOTICE
Perform visual inspection.
Before operational startup as well as after storage or transport, inspect the product
visually for signs of mechanical damage.
The product may not be put into operation if it has visible damage and/or is
defective.
Puro® Thermal Direct Printer YP-DP1
2 Safety instructions
EN-4
Minebea Intec
