5.2.3.2.1
Automatic reference optimization
If in the menu [OP.FUNC]- [A.OPT]- [ON] is set, the automatic reference optimization is
activated. The icon
is displayed in the "PW" display.
The main feature is the automatic more precise calculation of the sample weight.
The sample weight is recalculated during the optimization if the following conditions are
all met:
-
Scale is at a standstill
-
No prefix change
-
The current quantity exceeds the original reference quantity by at least two. The new
quantity may not exceed twice the old reference quantity (this limitation does not
apply for the first optimization if the sample weight was entered using a bar code
scanner or the keyboard).
-
The internally calculated quantity (e.g. 17.24) must be less than ± 0.3 parts different
from the whole number (in the example: 17).
-
If an optimization has been carried out, the icon
is displayed in the "PW"
display, and the newly calculated sample weight is also displayed in the "PW" display.
The automatic optimization is not carried out on scale 2.
5.2.3.3
Printouts (without checking)
Normal printout:
Printout
Description
441 pcs QNT
- 41 pcs QNT
MODE: COUNT
WREF 4.15431 oz
Positive value
Negative value
Activated application
Sample weight, same value as that displayed in the
"PW" display
.
Place a weight on the weighing pan.
The calculated number of parts is displayed in the "Count" display.
The application icon
(Counting) is displayed in the "Weight" display.
The actual weight value is displayed in the "Weight" display.
.
Briefly pressing the
key will generate a printout.
.
Pressing and holding the
key changes the unit in the "Weight" display (in
certain cases also in the "PW" display [see Chapter
]).
.
Briefly pressing the
key or the
key or the keypad starts an initialization
as described above.
.
Press and hold or briefly press the
key (see Chapter
)
.
Press the
key (see Chapter
.
Pressing the
key will delete the sample weight.
Compact scale Puro® LargeCount
5 Operating
EN-22
Minebea Intec
