5.3.2
Installing the mounting kit and inserting the load cell
Note:
Screw mounting of the upper and lower plates is described below.
The operations must be performed at all supporting points (e.g., vessel) of the weighing
object.
The load cell must always be mounted with the load disc downwards.
Requirements:
-
All threaded holes for the lower plate are available in the foundation/substructure
(see Chapter
).
-
All threaded holes for the upper plate are available in the vessel lug/vessel foot (see
Chapter
).
Procedure:
Example: PR 6012/31
1.
Fit the mounting kit to the vessel foot (5). It is essential to observe the property
classes and tightening torques of the screws (2) and the property classes of the
washers (3) (refer to Chapter
).
2.
Carefully position the vessel with mounting kit on the foundation/substructure (8)
using the mounting drill holes.
3.
Fasten the lower plate (7) to the foundation/substructure (8) and make sure that the
plates are in parallel and seated vertically above each other. It is essential to observe
the property classes and tightening torques of the screws (2) and the property classes
of the washers (3) (refer to Chapter
).
4. Clean the load cell seating in the upper and lower plates only when all welding work
near the weighing object and the mounting work on the weighing object have been
completed.
Mini FLEX and Mini FLEXLOCK mounting kits PR 6012/01, ../31, ../41
5 Installation
EN-18
Minebea Intec
