— A.PRINT
automatic printout
— OFF
disabled* (default setting)
— ON.STAB
automatic print on stability for one time, if
weight >1d
— INTER
automatic print at defined intervals of seconds
without
stability
— 25
Enter an interval in seconds in range from 1 to
3600
— CONT
automatic print at every weighing cycle
without
stability
— ACCEPT
automatic print for one time
with stability
within check limits
6.7
Auto-Print
A print is done automatically for
one time
if the Netto weight on the pan is ≥ 2d.
If the weight is removed from the pan and the Netto weight is <2d then the next Netto
weight ≥ 2d generates a print.
6.7.1
Menu-Selections
Set conditions at menu point [PRINT]:
6.7.2
Running Mode
-
Running Mode general (see chapter
)
-
Running Mode: ON STABLE (see chapter
)
-
Running Mode: INTER (see chapter
-
Running Mode: CONTNT (see chapter
)
-
Running Mode: ACCEPT (see chapter
)
6.7.2.1
Running Mode general
"Auto-Print" has second priority after "Auto-Tare". First weight on the pan is handled by
"Auto-Tare". The second weight on the pan is handled by "Auto-Print".
6.7.2.2
Running Mode: ON STABLE
An automatic printout is generated when the weight value is stable. This may be done
delayed. So the printout waits until the weight value is stable.
Each selected element in [PRINT] - [CONTNT] is printed except the functionality like
TOTALIZATION if it isn’t activated in menu.
This automatic print is generated
after
the weight is accumulated in TOTALIZATION with
AUTO-Mode. So TOTALIZATION has higher priority than Auto-Print.
6.7.2.3
Running Mode: INTER
An interval is to be selected in the menu. The selectable steps are in seconds starting from
1 to 3600 second.
Example: 5 seconds are selected, so each 5 seconds a printout is generated automatically.
The printout is done when the weight value is stable or not.
Each selected element in [PRINT] - [CONTNT] is printed except the functionality like
TOTALIZATION if it isn’t activated in menu.
6 Application Programs
Compact Scale Puro® Count
Minebea Intec
EN-33
