Minebea Intec EF-LT-3-P1, Руководство по эксплуатации

Страница: 23 / 86

Weight
Counting isn’t initialized
Weight
Counting is initialized
6.3.1 Initialization Mode
- Initialization by Sample (see chapter 6.3.1.1 )
- Initialization by known Piece Weight (see chapter 6.3.1.2 )
Count-Initialization is only possible on scale 1! Initialization is done with the internal scale
resolution.
6.3.1.1 Initialization by Sample
This initialization only takes place if the weight values are stable.
- Initialization (see chapter 6.3.1.1.1 )
- Initialization negative Sample (see chapter 6.3.1.1.2 )
These initializations are also possible if already a piece weight is calculated.
The input can be corrected via the Button which deletes the last digit of the input.
If the pan is unloaded (<2d) then the error message [REF.ERR] is displayed on Display-PW
for about two seconds.
Piece Weight
6.3.1.1.1 Initialization
6.3.1.1.2 Initialization negative Sample
If a negative Sample is required (= removing samples from a container):
1. Put a number of pieces on the pan.
2. Input the desired number of pieces on the pan via the key pad (only integer values) or
a scanner.
The input value will be displayed on Display-Count.
3. Then press the Button briefly.
The new calculated piece weight is displayed on Display-PW and the actual
calculated number of pieces is displayed on Display-Count.
1. Put a filled container on the pan.
2. Press the Button briefly (tare the weight).
3. Remove a number of pieces from the container.
Now a negative weight value is displayed on Display-Weight.
6 Application Programs Compact Scale Puro® Count
Minebea Intec EN-21