LCD DISPLAY:
Operating Directions:
Remove the overlay on the receiver (if you don’t, the numbers will never change – ha!!!)
Remove the battery compartment doors from the receiver and the RS-MX (RS211/213) remote transmitter.
Press “in” and push “down” on the RS-MX (RS211/213) remote rear cover. It should slide off easily.
Insert 2 “AAA” alkaline batteries in the indoor receiver (FIRST). After “powering up” the receiver, it will
search for a remote signal for 3 minutes.
Insert 2 “AAA” alkaline batteries in the RS-MX (RS211/213) remote transmitter. The temperature will appear
on the upper half of the screen and humidity on the lower half. “CH 1” will appear just to the left of the
humidity number. If/when you add a second and/or third remote, press the “CH” button inside the battery
compartment to choose either channels 2 or 3. You will probably need a magnifying glass if you really need
to see “CH2” or “CH3”. Suffice it to say, “CH1” is at the top left corner of the Humidity number, “CH2” is in
the middle and “CH3” is in the lower left.
Within three minutes, the remote temperature will appear on the receiver. Be sure the receiver is also set
on channel 1. If you do not see the remote information, press and release the “CH” button to check all 3
channels. If there has been no reception, press and hold the “CH” button for 2 seconds to force another 3
minute search.
Please understand that at this point even though the receiver and the remote are close together, the
temperatures will not match exactly. Due to electronic tolerances, it could take up to 48 hours for them to
come within 1°C (2°F). Don’t bother waiting (there is no point). You may relocate the RS-MX (RS211/213) at
any time. For location hints, see “Locating the Remote” at the end of these instructions.
If you are
adding a second or third
RS-MX (RS211/213) transmitter, install the batteries and set the channel
(on the remote) to either channel 2 or 3. On the receiver, press and hold the “Channel” button for 2 seconds.
All remote information will be cleared and the TempMinder® will search for new information. You should
see this new remote information within 3 minutes. Press the channel button (on the receiver) to scroll
through:
