MIMAKI UJF-605CII, Инструкция по ежедневному уходу

Страница: 3 / 24

3
Installation environment and Notes on cleaning
• Use this printer in clean (less dust) environment. The use of fan and ventilator might be
cause of dusty environment.
They brow dust up dust around the printer.
• As using UV curing ink, install this printer in a well-ventilated area.
• Working environmental temperature is 15 to 30 ° C (59 to 86 ° F). Avoid using at lower or
higher than this.
Notes on cleaning
• Never disassemble the device. Disassembling the device can result in
electric shock hazards and breakage of the device.
• Prevent moisture from entering inside the device. If the inner part of the
device becomes wet, electric shock hazards and breakage of the device
can result.
• Conduct maintenance works after turning off the power switch and detach-
ing the power cable. If not, unexpected troubles can arise.
• Make maintenance after the UV lamp has been sufficiently cooled, or burn
injury may occur.
• Do not use benzine, thinner and chemical agents containing abrasives.
Such materials can deteriorate or deform the surface of the cover.
• Do not apply lubricating oil or the like inside the device. Such materials
can cause the printer mechanism to fail.
• UJF-605C is a printer that uses ultraviolet ray curing ink (UV ink).. When
implementing the daily care, must wear supplied goggles and gloves.
• In case water or alcohol mixed into the organic solvent ink, flocculation
would be occurred. Be sure that not adhere water or alcohol to not only the
nozzle and also near the head, the cap, wiper and so on.