MIMAKI UJF-3042 MkII, Руководство пользователя

Страница: 8 / 24

For safe operation
8
• Using other than exclusive ink will break this
machine. In this case, repairing of this
machine is your responsibility.
• Never refill the ink bottle with ink.
• Do not pound the ink bottle nor shake it
violently. If so, ink may leak out of the bottle.
Protection against dust
• It is strongly recommended to use the
machine in a room that is not dusty.
Set the Refresh level 2 or 3 when in bad
environment.
• Do not forget to close the front cover before
going home in the evening. If any media is left
on the printer, dust can put on it.
• Store media not to put dust on it. Wiping dust
off the media, dust will be put on the media
due to static electricity.
Handling of cleaning solution
• Be sure to store the cleaning solution in a cold
and dark place. Store the cleaning solution in
a place that is out of the reach of children.
Handling the antifreeze liquid
• Be sure to store the antifreeze liquid in a cold
and dark place.
• Store the antifreeze liquid in a place that is out
of the reach of children.
Hot parts
• The LED UV device and the hot water will
have a very high temperature. When carrying
out maintenance, wait until the temperature
has been sufficiently lowered after the lamp is
turned OFF.
• When it is unavoidable to touch hot parts, be
sure to wear heat-insulating gloves to protect
your hands.
Power supply
• Leave the breaker turned ON.
• Do not turn off the main power switch on the
right side of this machine.
UV light
• A little UV light spills around the LED UV unit.
UV light applied to your skin might cause
inflammation and/or skin cancer.
Even weak UV light causing no inflammation
may lead to chronic disorders by repeated
exposure. Avoid applying UV light to your skin
and eyes.
• Impairment of eyes caused by UV light may be
acute disorders, pain in eyes, tearing, chronic
disorders, cataract, etc.
When using this machine, protect your body
such as gloves, long-sleeve cloth, light-
resistant mask, attached light-resistant
glasses, etc.
CAUTION
Notes on LED UV
• When handling the glass on the bottom of the
LED UV unit, be sure to wear the gloves
attached and never touch them with bare
hands. Or the UV ink curing level may
significantly lower. If the glass becomes dirty,
wipe it with clean gauze moistened with
alcohol. (Do not use alcohol for cleaning the
exterior cover, or the paint will peel off.)
• The LED UV performance and service life are
significantly affected by the UV irradiation and
UV power supply units used. Never use those
UV devices other than those recommended by
Mimaki. We would take no responsibility for
any troubles caused through the use of a UV
devices not recommended by Mimaki.
Cleaning
• After using this machine long time, foreign
materials and dust may be gathered on the
conductive and insulating parts, causing
electric leakage. Periodically clean such parts.
• For cleaning, do not use compressed air
because it scatters foreign materials and dust,
which may cause malfunctions when put
inside the conductive parts. Be sure to use
vacuum cleaner to vacuum off foreign
materials and dust.
• Do not use the machine in a place where there
is a possibility of being wet, or electricity may
leak.
• Electrical leakage may lead to electrical shock
of personnel or fire.
• To prevent accidents, be sure to carry out
periodic inspections and replace periodic
replacement parts.
Periodic exchange parts
• There are some parts which must be
periodically replaced. Contract with
distributors or dealers for maintenance.
Adjusting the level
• Keep this machine horizontal.
Firing and smoking
• Touching hot parts such as the LED UV with
combustible materials may cause firing and/or
smoking.
Leaving combustible materials under the LED
UV unit for a couple of minutes may also
cause firing and/or smoking.
CAUTION