MIMAKI Tx300P-1800B, Руководство по эксплуатации, Страница: 56 / 144

2-26
Chapter 2 Basic Operation
Set the media feeding
Correct the feeding rate of media.
If the correction value is not appropriate, stripes may appear on the printed image, thus resulting in a poor printing.
Flow of media feeding correction
Perform media feeding correction as below:
• When you have changed the media type, check the pattern and perform adjustment depending on the status.
• When printing with a take-up device, set the media first and then perform media correction.
1
2
3
Set the peeling roller to the
maximum torque.
6
Print the correction pattern.
If correction by counter weight/
torque adjustment is not
enough, input the correction
value in the feed correction
setting.
Referring to “Setting of Media Correction”
(
P.2-27).
Referring to “Setting the torque limiter”
(
P.2-17).
Referring to “Setting of Media Correction”
(
P.2-27).
Referring to “Setting of Media Correction”
(
P.2-27).
5
If correction by counter weight
adjustment is not enough,
adjust the torque. Referring to “Setting the torque limiter”
(
P.2-17).
Check that the feed correction
setting value is “0”.
4
Check the pattern and adjust
the counter weight of feeding/
take-up tension bar. Referring to “Tension Bar Weight Adjustment”
(
P.2-18).