MIMAKI TPC-1000, Меры безопасности

Страница: 9 / 20

Safety Precautions
9
• Specify the number of pinch rollers to be used which is suitable for the media width.
The position up to the specified pinch roller will be the printing or cutting area. ( See the
operation manual.)
• A pinch roller may move due to the automatic switching of the pinch roller pressure.
The position of the pinch roller itself may move by 0.5mm (maximum) due to the automatic switching
of the pinch roller pressure.
Be sure to use the application software corresponding to this device.
• For printing/cutting with TPC-1000, use RasterLinkPro4 and FineCut7 ([RL] mark is
indicated at the left bottom of the dialog).
If the conventional RasterLinkPro III or older version of FineCut which has no [RL] mark at the left
bottom of the dialog is used, when cutting data with the register mark, the register mark cannot be
detected.
• If the cutting software which does not support this device is used, some of the
function will not be operated.
For example, switching the machine to the cutting mode automatically from host computer cannot
be performed.
Other instruction
• Evacuate the cutter head with the dedicated key.
When moving cutter unit during media setting, evacuate the cutter head with the dedicated
CUTTER key.
Also, when replacing tools, use the maintenance/tool replacement function of cutting mode.
(
See the operation manual.)
With the above dedicated key, the cutter unit will move automatically from the current position to the
position where it will not interfere with the media set. Moving the cutter unit manually is very
dangerous and in addition, it causes the malfunction. Therefore, evacuate it as described above.
• For normal, printing/cutting width is determined inside the pinch roller, and for expand,
printing/cutting width is determined outside the pinch roller. Therefore, if printing/cutting is
performed using whole area, check if the required size is recognized and then print/cut.
• If the required size is not recognized, check the position of pinch rollers and detect the
media width.
1) When pinch rollers are fewer against the media width
The balance of the media feeding will be lost, and the feeding
accuracy will be lower or the feeding will not be performed
properly.
2) When pinch rollers are more against the media width
• A pinch roller at the position where there is no media hits
against the grit roller directly and the pinch roller may be
chipped off.
• As the media width cannot be recognized correctly, printing or
cutting is performed on outside of the media.