MIMAKI Kebab MKII, Руководство по эксплуатации

Страница: 43 / 56

Test drawing
43
Test drawing
Before drawing, perform test drawing and check that there is no drawing defect such as nozzle clogging (slight
touching of ink or nozzle missing).
1
Set the media for test drawing at
the rear of Kebab MkII system/
Kebab MkII L system.
• Attach the media with a tape or something similar.
2
By referring to the Chapter 2 “Perform
test drawing” of the operation manual of
the using printer, perform the test draw-
ing.
• The origin of X and Y and the height of head are
automatically set.
• When choosing the SCAN direction, printing is done in order
of  →  →  ···. When exceeding the print area, it returns to
the position of  .
• When choosing the FEED direction, printing is done at the position of  .
• Check the drawn result and when it is normal, draw the data.
• If an abnormality occurs, perform head cleaning. (Refer to the Chapter 2 “Perform head cleaning” of the oper-
ation manual of the using printer.)
• In case of using UJF-3042MkIIseries or UJF-
6042MkIIseries while taking off two sustaining
shafts (the work diameter is more than
65mm), perform the test drawing by setting a
provided dummy table.
• When drawing on an actual work after performing a test drawing, it returns to the original point that was set
in the process of the start position of the drawing ( P.41) .
• When doing a test drawing, remove the work holder. If there is the work holder, a drawing may have
unintended gaps.
Attach the media
with a tape or
something similar.
[ Kebab MkII system ] [ Kebab MkII L system ]
Dummy table 60
Dummy table 30
[ X ]
[ Y ]
㪤㪼㪻㫀㪸
㪛㫌㫄㫄㫐㩷㫋㪸㪹㫃㪼
When SCAN direction is choosed