MIMAKI JV4 Series, Руководство по эксплуатации

Страница: 66 / 152

- 1.48 -
SETTING OF AN ORIGIN
If you want to perform printing at another location of a roll medium that provides a wider printing
area, it is necessary to re-establish another origin.
STEP
1. After the medium detection is completed, move
the carriage to the position at which to estab-
lish an origin by pushing the JOG keys [ ],
[ ], [ ], and [ ].
As the carriage is moved, the origin shifts in position. The
origin that changes with the movement of the carriage is
displayed on the LCD.
2. After deciding the origin, push the [ENTER]
key.
The origin has been changed.
The effective plotting area is displayed on the LCD, and the
device enters the LOCAL mode.
When a roll medium is used, X (medium length) is not
detected, hence it is not displayed on the LCD either.
When the device starts plotting the next time, it uses the
origin that has been established unless the origin is changed.
ORIGIN SET UP
0.0 0.0
<< LOCAL >>
width : 1272mm
ORIGIN
X=1500mm Y=972mm
Origin(Length)
Relative distance
from the origin
Origin (width)
Relative distance
from the origin
Medium length
minus position of
origin (effective
plotting area)
Medium width
minus position of
origin (effective
plotting area)