MIMAKI CJV30 Series, Руководство по обслуживанию

Страница: 99 / 316

© 2009 MIMAKI ENGINEERING CO.,LTD. 4.2.3 P.1
1
2
3
4
5
6
7
8
R.1.1
Maintenance Manual > Adjustment Items > Adjustment Function > EDGE ADJUST
Model CJV30/TPC Issued 2008.08.04 Revised 2008.09.17 F/W ver. 1.20 Remark
1.1
Rev.
4.2.3 EDGE ADJUST
 Function
Adjust the width of the each dead space of the right and left ends of the media.
Since media detection is carried out by the pinch roller, make adjustment so that location of patterns is inside both ends
of the pinch roller, which is the usable plot area.
Is used when the system parameter has been initialized or the (plot areas at both ends) are not in the right place.

Procedure
1. Select [EDGE ADJUST] from the operation menu.
2. Draw an adjustment pattern.
[

]: Set adjust values of L and R to default (0.0 mm).
[

]: Execute media width detection to draw an
adjustment pattern.
[

]: To the screen for adjustment (Without drawing)
3. Check the adjustment pattern.
4. Enter the adjustment value.
For adjustment, input actual values obtained by measuring from
the inner end of the pinch roller to the pattern.
Adjusting value: 0.0 to 35.0 mm (unit: 0.1 mm)
(Use the inside of pinch roller as a positive (+). The backlash of
the pinch roller may produce an error of approx. ± 0.5 mm.
[

] / [

]: Changes adjustment values.
[END]: Cancellation of input
Media width
Left end of pinch roller
Right end of pinch roller
<LOCAL.

> [#01]
FUNCTION
#ADJUST <ent>
#ADJUST / PRINT
EDGE ADJUST <ent>
[FUNCTION]
Make adjustment with [EXPANDS] of [COMMON
SETUP] turned OFF.
#EDGE ADJUST
CLEAR < > PRINT
Pattern drawing
Media width
#EDGE ADJUST
L=15.0 R=15.0
 The set value is saved in the system parameter No.2
R GRIP and No.3 L GRIP.