MIMAKI CJV30 Series, Руководство по обслуживанию

Страница: 124 / 316

© 2009 MIMAKI ENGINEERING CO.,LTD. 4.3.1 P.1
1
2
3
4
5
6
7
8
R.1.1
Maintenance Manual > Adjustment Items > Mechanical Adjustment > Adjusting the Location of Mark Sensor
Model CJV30/TPC Issued 2008.08.04 Revised 2008.09.17 F/W ver. 1.20 Remark
1.1
Rev.
4.3.1 Adjusting the Location of Mark Sensor
 Function
Adjust the distance between the mark sensor (photo sensor) and the platen to the specified value.
 Procedure
1. From the back side of the printer, loosen the screws that hold
the T sensor BKT.
2. Insert the clearance gauge between the pen line film and the
bottom surface of the T sensor cover.
3. Check whether the right and left T sensor covers are fixed under
the conditions that each of them is in close contact with the
clearance gauge, then tighten up the screws.
 Set the pressure of all the clamps to Middle, and make the adjustment on the right station side.
 This adjustment is to be made mechanically without using any [#ADJUST] item. After completion of
this adjustment, however, make the adjustments of [PHOTO SENSOR] among the [#ADJUST] items.
2.8 mm
T Sensor BKT
Loosen
When no sheet is set: the plotter waits for input of a
compensation value without plotting.
Jig for adjusting the height
of CJV mark sensor
T Sensor Cover
Fix.
Press against.